Introduction

Replace a broken fuse on the TRS-80 Color Computer's power supply.

Flip the computer over.
  • Flip the computer over.

  • Remove the two 24.1mm Phillips screws near the front of the case.

  • Remove the five 33.0 mm Phillips screws towards the back of the case.

Ajouter un commentaire

Carefully flip the computer right side up.
  • Carefully flip the computer right side up.

  • Lift off the top half of the case.

Ajouter un commentaire

  • Near the motherboard, gently pull the keyboard ribbon cable until it becomes free.

  • Lift the keyboard out of the case.

Ajouter un commentaire

  • Remove the nine 15.24 mm Phillips screws securing the motherboard in place.

  • When removing the spring door, make sure to keep the door closed.

Ajouter un commentaire

  • Remove the 5 jumper cables from the motherboard.

  • Once the jumper cables lift the motherboard up gently; it should lift out easily.

Ajouter un commentaire

  • Remove the two 40.6mm Philips screws securing the TRS-80 transformer.

Ajouter un commentaire

  • Remove the power cable jumpers from the power supply.

Ajouter un commentaire

  • Gently peel back the protective film on the top of the transformer.

Ajouter un commentaire

  • Locate the two points the fuse is soldered into the circuit board.

  • Using a soldering iron and soldering wick, desolder and remove the fuse.

  • Place the new fuse into the location of the old one, and solder it in place.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Christopher Paige

Membre depuis le 21/01/2011

495 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 11-24, Maness Winter 2011 Membre de l'équipe Cal Poly, Team 11-24, Maness Winter 2011

CPSU-MANESS-W11S11G24

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 7

Total : 2,058