Introduction

Replace the aging built-in keyboard.

Pièces

Aucune pièce nécessaire.

Flip the computer over.
  • Flip the computer over.

  • Remove the two 24.1mm Phillips screws near the front of the case.

  • Remove the five 33.0 mm Phillips screws towards the back of the case.

Ajouter un commentaire

Carefully flip the computer right side up.
  • Carefully flip the computer right side up.

  • Lift off the top half of the case.

Ajouter un commentaire

  • Near the motherboard, gently pull the keyboard ribbon cable until it becomes free.

  • Lift the keyboard out of the case.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Christopher Paige

Membre depuis le 21/01/2011

495 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 11-24, Maness Winter 2011 Membre de l'équipe Cal Poly, Team 11-24, Maness Winter 2011

CPSU-MANESS-W11S11G24

4 membres

5 tutoriels rédigés

This only applies for Color Computers issued after the CoCo 1 F Board (as shown) RS catalog 26-3004 and subsequent models (CoCo 2 & 3). Early editions of the CoCo 1 had not a mylar ribbon cable like this but a heavier ribbon composed of actual wires, the connector they went into was also built for this type of ribbon. The keyboards on each category of connecting ribbon are sadly not interchangeable.

Rogelio Perea - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 16

Total : 1,971