Réparez vos affaires Communauté Boutique

TRS-80 Color Computer Keyboard Replacement

Introduction

Replace the aging built-in keyboard.

Ce dont vous avez besoin

  1. TRS-80 Color Computer Keyboard Replacement, Outside Casing: étape 1, image 1 de 1

    • Flip the computer over.

    • Remove the two 24.1mm Phillips screws near the front of the case.

    • Remove the five 33.0 mm Phillips screws towards the back of the case.

    Modifier

  3. TRS-80 Color Computer Keyboard Replacement: étape 2, image 1 de 2 TRS-80 Color Computer Keyboard Replacement: étape 2, image 2 de 2

    • Carefully flip the computer right side up.

    • Lift off the top half of the case.

    Modifier

  4. TRS-80 Color Computer Keyboard Replacement, Keyboard: étape 3, image 1 de 2 TRS-80 Color Computer Keyboard Replacement, Keyboard: étape 3, image 2 de 2

    • Near the motherboard, gently pull the keyboard ribbon cable until it becomes free.

    • Lift the keyboard out of the case.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autres ont terminé cette réparation.

Auteur

avec 5 autres contributeurs

Christopher Paige

Membre depuis le 01/21/11

549 Réputation

3 tutoriels rédigés

Badges: 11

+ 8 badges supplémentaires

Équipe

Cal Poly, Team 11-24, Maness Winter 2011 Membre de l'équipe Cal Poly, Team 11-24, Maness Winter 2011

CPSU-MANESS-W11S11G24

4 membres

10 tutoriels rédigés

Un commentaire

This only applies for Color Computers issued after the CoCo 1 F Board (as shown) RS catalog 26-3004 and subsequent models (CoCo 2 & 3). Early editions of the CoCo 1 had not a mylar ribbon cable like this but a heavier ribbon composed of actual wires, the connector they went into was also built for this type of ribbon. The keyboards on each category of connecting ribbon are sadly not interchangeable.

Rogelio Perea - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 8

Total : 3,195