Tent Pole Shock Cord Replacement

Introduction

This guide will illustrate how to replace the shock cord in tent poles with a bobby pin and string. There are many other methods that can be used to feed the shock cord through tent poles, but when away from home, a bobby pin and string can save the day.

Ce dont vous avez besoin

Étape 1 Tent Pole Shock Cord

Tent Pole Shock Cord Replacement, Tent Pole Shock Cord: étape 1, image 1 de 1

Remove the old shock cord from the tent poles.

Modifier

Étape 2

Measure and cut the string to the length of one tent pole piece.
Be sure to leave enough room on each end for knots.

Modifier

Étape 3

Tie the string to the end of the shock cord.

Modifier

Étape 4

Use your hands or pliers to flatten out a bobby pin.
Any long, thin, metal object will work to help feed the string and cord through the poles.

Modifier

Étape 5

Tie the string around the end of the bobby pin.
The string and bobby pin will be used to feed the shock cord through the pole.

Modifier

Étape 6

Tent Pole Shock Cord Replacement: étape 6, image 3 de 3

Drop the bobby pin and string through the tent pole pieces one by one.
Once the bobby pin reaches the opposite end of each pole, slowly pull the string to feed the shock cord through.

Modifier

Étape 7

Once the last piece has been threaded, untie or cut the string from the shock cord.
Tie a large knot against the right end of the last piece.
The knot must be large enough to prevent the shock cord from slipping through the pole.

Modifier

Étape 8

Connect the tent poles.

Modifier

Étape 9

Cut the shock cord from the left end of the first pole piece leaving room on the end for knots.
Leaving extra shock cord on the end will also allow you to adjust the tension in the shock cord later on.

Modifier

Étape 10

Tie a large knot around the tent pole end piece.
Fit the end piece into the left end of the first pole.
If your poles do not come with an end piece, simply tie a large knot in the shock cord. The knot must be large enough to prevent the shock cord from pulling through.

Modifier

Étape 11

Disconnect the pole pieces.
Fold the pieces to test the shock cord tension.
If the shock cord is too tight, reconnect the poles and adjust the shock cord length between the left end of the first pole and the end piece.