Introduction

In this guide the push button is replaced. If the button is no longer working or the button is sticky this is the guide for you.

Unscrew the seven screws located on the back of the device.
  • Unscrew the seven screws located on the back of the device.

Ajouter un commentaire

Slide the plastic the spudger along the edge of the device to separate the keyboard tray.
  • Slide the plastic the spudger along the edge of the device to separate the keyboard tray.

Ajouter un commentaire

  • Flip the device over and open it to lift the keyboard tray from the body of the device.

Ajouter un commentaire

  • Use the Plastic Spudger to gently release the ribbon cable attached to the keyboard.

  • Place device to side.

Ajouter un commentaire

  • Unlock and remove the 3 ribbon cables along the top of the keyboard tray.

Ajouter un commentaire

  • Locate and unscrew the 3 silver screws.

Ajouter un commentaire

  • Gently wiggle and lift the Push Button board from the keyboard tray.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kirby Raines

Membre depuis le 23/01/2018

627 Réputation

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 5

30 derniers jours : 23

Total : 109