Introduction

Use this guide will show how to replace the USB cable.

Please note that this guide requires soldering. For more information on how to solder and desolder connections, please visit this guide.

Remove the black 10mm using a JIS #1 screw driver.
  • Remove the black 10mm using a JIS #1 screw driver.

  • There are 12 screws.

  • Two of the screws are deep inside the device you might need to use a slim screwdriver.

  • In the picture you see a plastic opining tool instead of screw driver because we did not have our screw driver when we were taking the picture.

Ajouter un commentaire

Remove the two 10mm black screws on the top of device using a Hex 2.5mm Key. Only the two outside screws.
  • Remove the two 10mm black screws on the top of device using a Hex 2.5mm Key. Only the two outside screws.

  • Gently pull apart both halves of device to access inside.

Ajouter un commentaire

  • Using a small plastic opening tool, gently pry up the white connector that connects the USB cable to the board.

Ajouter un commentaire

  • Desolder the black cable that connects the USB port to the motherboard.

  • For more information on how to solder and desolder connections, please visit this guide.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mario Nunez

Membre depuis le 18/10/2017

316 Réputation

3 tutoriels rédigés

Équipe

USF Tampa, Team S1-G33, Cagle Fall 2017 Membre de l'équipe USF Tampa, Team S1-G33, Cagle Fall 2017

USFT-CAGLE-F17S1G33

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 6

7 derniers jours : 27

30 derniers jours : 152

Total : 1,015