Aller au contenu principal

Introduction

The hard drive is the component capable of storing recordings. This information is vital in case the TiVo does not record the desired shows.

Pièces

Aucune pièce spécifiée.

  1. Power down the TiVo Premiere XL4 by detaching the power cable from the unit and power source.
    • Power down the TiVo Premiere XL4 by detaching the power cable from the unit and power source.

    • Allow the box to cool for at least 5 minutes before proceeding to the next step.

  2. Remove the four 80 mm T10 screws from the back of the TiVo box using theTorx screwdriver. Remove the four 80 mm T10 screws from the back of the TiVo box using theTorx screwdriver.
    • Remove the four 80 mm T10 screws from the back of the TiVo box using theTorx screwdriver.

  3. Take the outer casing by sliding the top of the box off of the component carefully, making sure not to damage the surrounding components inside.
    • Take the outer casing by sliding the top of the box off of the component carefully, making sure not to damage the surrounding components inside.

  4. Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now

    Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now
  5. Pinch the connector of the bundle of wires (the bundle having black, red, black and yellow wires) and gently remove from the motherboard. Pinch the connector of the single flat wire and gently remove from motherboard. Pinch the connector of the single flat wire and gently remove from motherboard.
    • Pinch the connector of the bundle of wires (the bundle having black, red, black and yellow wires) and gently remove from the motherboard.

    • Pinch the connector of the single flat wire and gently remove from motherboard.

  6. Unscrew the following two 80 mm T10  screws connecting the hard drive to the bottom of the box using the Torx screwdriver. Repeat on the other side of the hard drive.
    • Unscrew the following two 80 mm T10 screws connecting the hard drive to the bottom of the box using the Torx screwdriver.

    • Repeat on the other side of the hard drive.

    • There will be a total of four 80 mm T10 screws removed.

  7. Remove hard drive from box.
    • Remove hard drive from box.

  8. Remove the marked (2) T10 screws and washers using a Torx Screwdriver.
    • Remove the marked (2) T10 screws and washers using a Torx Screwdriver.

    • Repeat on the opposite side for (2) T10 screws.

    • Remove the connecting cable.

    • Keep the fasteners if the hard drive needs to be replaced.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Frances Prewitt

Membre depuis le 22/10/2018

637 Réputation

6 tutoriels rédigés

Équipe

Baylor, Team S1-G1, Williams Fall 2018 Membre de l'équipe Baylor, Team S1-G1, Williams Fall 2018

BU-WILLIAMS-F18S1G1

3 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 96