Introduction

In case your remote just won't work and you have already tried replacing the batteries, this guide will walk you through removing the front cover and replacing the remote sensor on the inside of the cover.

Pièces

Aucune pièce nécessaire.

Unscrew the five 0.31 inch T-9 screws on the back cover.
  • Unscrew the five 0.31 inch T-9 screws on the back cover.

Ajouter un commentaire

Slide the cover towards the back until it is no longer under the front cover.
  • Slide the cover towards the back until it is no longer under the front cover.

Ajouter un commentaire

Lift the cover up and off the device.
  • Lift the cover up and off the device.

Ajouter un commentaire

Unplug the ribbon cable from the motherboard. Some force may be required for this step, so be careful not to rip the ribbon cable.
  • Unplug the ribbon cable from the motherboard. Some force may be required for this step, so be careful not to rip the ribbon cable.

Ajouter un commentaire

Unscrew the two 0.31 inch T-9 screws on the inside of the front cover.
  • Unscrew the two 0.31 inch T-9 screws on the inside of the front cover.

Ajouter un commentaire

Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover. Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover. Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover.
  • Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover.

Ajouter un commentaire

Pull the front cover down and away from the device to separate it completely. Be careful not to tear the ribbon cable as you are removing the front cover.
  • Pull the front cover down and away from the device to separate it completely. Be careful not to tear the ribbon cable as you are removing the front cover.

Ajouter un commentaire

Unscrew the two 0.31 inch T-9 screws on the back of the sensor.
  • Unscrew the two 0.31 inch T-9 screws on the back of the sensor.

Ajouter un commentaire

Lift the sensor up to remove it.
  • Lift the sensor up to remove it.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Shauna

Membre depuis le 10/10/2011

37 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 5-33, Amido Fall 2011 Membre de l'équipe Cal Poly, Team 5-33, Amido Fall 2011

CPSU-AMIDO-F11S5G33

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 896