Pièces

Aucune pièce nécessaire.

  1. Power down the TiVo and detach the power cable from the rear of the unit.
    • Power down the TiVo and detach the power cable from the rear of the unit.

    • Wait 5 minutes for the unit to fully discharge before proceeding to the next step.

  2. Remove the five T10 screws from the rear of the case using the Torx screwdriver.
    • Remove the five T10 screws from the rear of the case using the Torx screwdriver.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Lift up and pull back the outer casing towards the rear of the unit. Lift up and pull back the outer casing towards the rear of the unit.
    • Lift up and pull back the outer casing towards the rear of the unit.

  5. The fan is held in by four T15 screws on the rear of the device.
    • The fan is held in by four T15 screws on the rear of the device.

  6. Take the wound red and black wires coming from the fan and follow them back to the logic board. Unplug the connector from the motherboard.
    • Take the wound red and black wires coming from the fan and follow them back to the logic board.

    • Unplug the connector from the motherboard.

  7. Pull the fan towards the front and out of the TiVo unit. Pull the fan towards the front and out of the TiVo unit.
    • Pull the fan towards the front and out of the TiVo unit.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Svyatoslav Markeyev

Membre depuis le 16/04/2010

135 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 33-79, Johann Spring 2010 Membre de l'équipe Cal Poly, Team 33-79, Johann Spring 2010

CPSU-JOHANN-S10S33G79

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 5,075