Toguard C200 Battery Replacement

Introduction

This guide is made to show you how to replace a super capacitor battery from the Toguard C200 model. If you are experiencing difficulties charging the camera or keeping the camera on even after charging it, a battery replacement should fix the problem.

Note: This C200 dash cam needs to be connected to a 5V 2A external power supply when in use to stay powered on.

Ce dont vous avez besoin

Étape 1 Battery

Toguard C200 Battery Replacement, Battery: étape 1, image 1 de 2

Toguard C200 Battery Replacement, Battery: étape 1, image 2 de 2

Use a suction handle to remove the screen from the camera.

Modifier

Étape 2

Use an opening tool to pry off the bezel.

Modifier

Étape 3

Use a Phillips screwdriver to unscrew the 4 screws to access the battery underneath.
Lift the motherboard slightly.
Make sure to keep all the screws together to not misplace any of them.

Modifier

Étape 4

Outil utilisé dans cette étape :

Tweezers

$4.99

J'achète

Use the tweezers and your hands to remove the battery from its original place.

Modifier

Étape 5

Notice the connection of + and - on the top left side of the inside of the dash cam. Make note of this as it will be important to remember when you solder on the new battery
Desolder the old battery.
Heat the solder by using the soldering iron until it starts to melt. Try nudging the pins with the soldering iron to move the solder away from the joints. Pull the components you want to remove with the pliers.
Solder the new battery and make sure the + and - wires correctly match the motherboard. (Any super capacitor of 200mAh or higher will work)