Introduction

Have fun with this great disassembly guide!

Pièces

Aucune pièce nécessaire.

The full product in its original state.
  • The full product in its original state.

Ajouter un commentaire

Remove  the nozzle by pressing the white button on the top of the product just under the name of the brand.
  • Remove the nozzle by pressing the white button on the top of the product just under the name of the brand.

Ajouter un commentaire

  • Remove the big parts that are inside of the nozzle. These parts consist of a plastic structure with a filter.

Ajouter un commentaire

  • Remove the rubber fitting from the inside of the nozzle by pulling it from the metal pieces.

Ajouter un commentaire

  • Remove the blue switchbutton from the upper part of the nozzle by putting a momentum on the edge. After you have this signature move you can remove the brush. You can see the video for the signature move.

Ajouter un commentaire

  • Remove the blue switchbutton from the upper part of the nozzle by putting a momentum on the edge. After you have done this signature move you can remove the brush.

Ajouter un commentaire

  • Right now the whole nozzle is disassembled, except for two small steel rings. These will break if you try to remove them.

Ajouter un commentaire

  • Now the nozzle is disassembled we can start with the body.

Ajouter un commentaire

  • Remove 4 screws on the side and 1 screw on the bottom. You'll do this by crosshead screwdriver size number 1.

Ajouter un commentaire

  • Remove the black clip from the inner top side of the body.

Ajouter un commentaire

  • Remove the lid from the battery lid by sliding it and after pull it out.

Ajouter un commentaire

  • Remove the screw after removing the lid above the battery.

Ajouter un commentaire

  • Seperate the two body parts.

Ajouter un commentaire

  • Remove the turbine protector in front of the turbine.

Ajouter un commentaire

  • Pull the battery out. It still has some wires attached to it.

Ajouter un commentaire

  • Use the pliers to remove the wires from the battery.

Ajouter un commentaire

  • Pull the charge socket out of the plastic cover.

Ajouter un commentaire

  • Remove the button from the body.

Ajouter un commentaire

  • Pull the button off the switch.

Ajouter un commentaire

  • Remove the last screw with a number 1 screwdriver, next to the electro motor to release the motor + turbine.

Ajouter un commentaire

  • The remaining part consists of moving pieces that cannot be disassembled.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Koen Tijhuis

Membre depuis le 07/03/2018

313 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 36