Introduction

This guide is really simple. It only involves unscrewing one screw!

Remove the 2 rubber foot pads from the bottom with the small Plastic Opening tool.
  • Remove the 2 rubber foot pads from the bottom with the small Plastic Opening tool.

Ajouter un commentaire

Remove the 10 7.1 mm screws using Phillips #1 screwdriver.
  • Remove the 10 7.1 mm screws using Phillips #1 screwdriver.

Ajouter un commentaire

  • Loosen the back cover by using a plastic opening tool all the way around the device.

    • There are areas all along the sides of the device that help aid in this.

Ajouter un commentaire

  • Remove the back cover by gently lifting up on one side of the device.

    • The easiest side to lift up on is the one with the removed rubber foot pads.

Ajouter un commentaire

  • Remove the tape holding the speaker wire to the battery on both sides using a small opening tool.

Ajouter un commentaire

  • Remove the 4 Phillips 3.2 mm screws holding the battery in place, with the Phillips #1 screwdriver.

Ajouter un commentaire

  • To disconnect the wire from the mother board, gently press down with the flat end of Spudger and pull on the wire.

    • Gently shaking the wire from left to right helps with the wire removal

Ajouter un commentaire

  • Remove the battery by gently pulling on the bottom corners.

    • Be careful to move the battery's wire under the speaker's wire.

Ajouter un commentaire

  • Location of the SSD card

Ajouter un commentaire

  • Remove the Phillips 3.6 mm screw using a Phillips #1 screwdriver.

Ajouter un commentaire

  • Remove the yellow tape by slowly peeling it away at the bottom on the SSD.

Ajouter un commentaire

  • Remove the SSD card from the motherboard by gently pulling up on the side where the screw originally was and out in the same direction.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jillian Thomas

Membre depuis le 14/10/2017

150 Réputation

4 tutoriels rédigés

Équipe

USF Tampa, Team S1-G121, Cagle Fall 2017 Membre de l'équipe USF Tampa, Team S1-G121, Cagle Fall 2017

USFT-CAGLE-F17S1G121

3 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 5

30 derniers jours : 32

Total : 194