1. Use a spudger to remove the small rubber screw coverings above each retaining screw. Use the bit driver with a Phillips #0 bit to remove the two 5 mm screws securing the screen bezel.
    • Use a spudger to remove the small rubber screw coverings above each retaining screw.

    • Use the bit driver with a Phillips #0 bit to remove the two 5 mm screws securing the screen bezel.

  2. Using a spudger, gently pry the screen bezel to the condition of the photograph. For this procedure, it is not necessary to completely removal screen bezel so in order to reduce work, bezel is just partially removed. For this procedure, it is not necessary to completely removal screen bezel so in order to reduce work, bezel is just partially removed.
    • Using a spudger, gently pry the screen bezel to the condition of the photograph.

    • For this procedure, it is not necessary to completely removal screen bezel so in order to reduce work, bezel is just partially removed.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Using pliers, gently remove the electrical connection to the webcam by pulling the plug to the right (per orientation of the photo). Allow the removed wire to hang in place but make note of alignment with respect to webcam.
    • Using pliers, gently remove the electrical connection to the webcam by pulling the plug to the right (per orientation of the photo).

    • Allow the removed wire to hang in place but make note of alignment with respect to webcam.

    • This step is performed while holding down the bezel which is only partially detached.

  5. Use the spudger to pry each side of the webcam until it releases from its adhesive back. Use the spudger to pry each side of the webcam until it releases from its adhesive back. Use the spudger to pry each side of the webcam until it releases from its adhesive back.
    • Use the spudger to pry each side of the webcam until it releases from its adhesive back.

  6. Position the new webcam in the old webcam's position. The webcam must be carefully aligned in order to function properly with the bezel in place. Align the hole of the webcam assembly over the cylinder of the webcam stabilizer. Reconnect the electrical connection.
    • Position the new webcam in the old webcam's position. The webcam must be carefully aligned in order to function properly with the bezel in place. Align the hole of the webcam assembly over the cylinder of the webcam stabilizer.

    • Reconnect the electrical connection.

  7. Gently press the front bezel back into its original position. Using the bit driver and Phillips #0 bit, drive the two bezel retaining screws in to place. Cover the screws with the small covers with tweezers.
    • Gently press the front bezel back into its original position.

    • Using the bit driver and Phillips #0 bit, drive the two bezel retaining screws in to place.

    • Cover the screws with the small covers with tweezers.

Ligne d'arrivée

Mason McCaskill

Membre depuis le 18/10/2013

943 Réputation

9 tutoriels rédigés

Équipe

Clemson, Team 14-2, Benson Fall 2013 Membre de l'équipe Clemson, Team 14-2, Benson Fall 2013

CLEM-BENSON-F13S14G2

3 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 4

Total : 369