Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

This guide will go through the steps needed to install a new hard drive.

Pièces

Aucune pièce spécifiée.

  1. Turn the computer over onto its back.
    • Turn the computer over onto its back.

  2. Slide the lock on the left side to the unlock position. Slide the lock on the right side to the unlock position until there is a clicking sound.
    • Slide the lock on the left side to the unlock position.

    • Slide the lock on the right side to the unlock position until there is a clicking sound.

  3. OUVRIR TOUS LES ONGLETS

    Kits de mise à jour de RAM pour Mac

    Voir les kits

    Assez de RAM
    pour ouvrir tous les onglets

    Voir les kits
  4. Remove the battery by sliding it out while both locks remain in the unlock position. Remove the battery by sliding it out while both locks remain in the unlock position.
    • Remove the battery by sliding it out while both locks remain in the unlock position.

  5. Turn the computer over onto the back. Use a Phillips head screwdriver to remove the screw from the hard drive cover. One 8.5 mm fine thread screw.
    • Turn the computer over onto the back.

    • Use a Phillips head screwdriver to remove the screw from the hard drive cover.

    • One 8.5 mm fine thread screw.

    • Lift and remove the cover.

  6. Carefully remove the hard drive from the IDE cable by pulling on the black connector (do not pull the orange cable). Carefully remove the hard drive from the IDE cable by pulling on the black connector (do not pull the orange cable). Carefully remove the hard drive from the IDE cable by pulling on the black connector (do not pull the orange cable).
    • Carefully remove the hard drive from the IDE cable by pulling on the black connector (do not pull the orange cable).

  7. Remove the two gray rubber covers from  both ends of the hard drive. Remove the two gray rubber covers from  both ends of the hard drive.
    • Remove the two gray rubber covers from both ends of the hard drive.

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Alison Wendt

Membre depuis le 18/04/2013

96 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 21-51, Johann Spring 2013 Membre de l'équipe Cal Poly, Team 21-51, Johann Spring 2013

CPSU-JOHANN-S13S21G51

3 membres

6 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 14

Total : 1,779