Introduction

This guide will go through the steps needed to install a new wireless card.

  1. Turn the computer over onto its back.
    • Turn the computer over onto its back.

  2. Slide the lock on the left side to the unlock position. Slide the lock on the right side to the unlock position until there is a clicking sound.
    • Slide the lock on the left side to the unlock position.

    • Slide the lock on the right side to the unlock position until there is a clicking sound.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Remove the battery by sliding it out while both locks remain in the unlock position. Remove the battery by sliding it out while both locks remain in the unlock position.
    • Remove the battery by sliding it out while both locks remain in the unlock position.

  5. Turn the computer onto the back. Remove the Phillips #0 screw that secures the cover to the rest of the device. One 5.1 mm coarse thread screw.
    • Turn the computer onto the back.

    • Remove the Phillips #0 screw that secures the cover to the rest of the device.

    • One 5.1 mm coarse thread screw.

    • Pull the cover forward to release it.

  6. Use a Phillips #1 screwdriver to remove the two screws on opposite corners of the wireless card. Two 4.0 mm coarse thread screws. Use a plastic opening tool to gently lift the wireless card out while leaving the wire connected.
    • Use a Phillips #1 screwdriver to remove the two screws on opposite corners of the wireless card.

    • Two 4.0 mm coarse thread screws.

    • Use a plastic opening tool to gently lift the wireless card out while leaving the wire connected.

  7. Hold the edges of the wireless card and carefully disconnect the black 3 pin connector. Hold the edges of the wireless card and carefully disconnect the black 3 pin connector.
    • Hold the edges of the wireless card and carefully disconnect the black 3 pin connector.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Alison Wendt

Membre depuis le 18/04/2013

78 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 21-51, Johann Spring 2013 Membre de l'équipe Cal Poly, Team 21-51, Johann Spring 2013

CPSU-JOHANN-S13S21G51

3 membres

6 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 582