Aller au contenu principal

Introduction

Remove the RAM in order to replace the memory, use this procedure after completing a memory test and assuring the RAM has failed.

  1. Identify the rectangular plastic RAM cover located in the bottom part of your laptop.
    • Identify the rectangular plastic RAM cover located in the bottom part of your laptop.

    • Remove the 4mm flat-head screws on the RAM cover.

    • Use a plastic opening tool to pry the RAM cover upward.

  2. Use a plastic opening tool to pry the RAM cover upward.
    • Use a plastic opening tool to pry the RAM cover upward.

    • Remove the RAM cover.

  3. Batteries pour ordinateurs portables

    Batteries pour toutes les grandes marques d'ordinateurs portables. Qualité assurée par notre garantie.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Batteries pour toutes les grandes marques d'ordinateurs portables. Qualité assurée par notre garantie.

    Acheter maintenant
  4. Press the two tabs on the side of the PC2-5300 2 GB RAM Chip to unlatch it.
    • Press the two tabs on the side of the PC2-5300 2 GB RAM Chip to unlatch it.

    • To remove the PC2-5300 2 GB RAM Chip, pull it out at a slightly upward angle.

  5. To replace the ram, insert the new PC2-5300 1 GB RAM Chip you have gathered back into the laptop. Make sure the notch in the middle of the stick is lined up correctly and push firmly into place.
    • To replace the ram, insert the new PC2-5300 1 GB RAM Chip you have gathered back into the laptop.

    • Make sure the notch in the middle of the stick is lined up correctly and push firmly into place.

    • Once pushed firmly into place, firmly push down and latch the RAM sticks to the laptop. Repeat process for additional RAM sticks.

  6. To replace the ram, insert the new RAM sticks you have back into the computer. Make sure the notch in the middle of the stick is lined up correctly and push firmly into place.
    • To replace the ram, insert the new RAM sticks you have back into the computer.

    • Make sure the notch in the middle of the stick is lined up correctly and push firmly into place.

    • Once pushed firmly into place, firmly push down and latch the RAM sticks to the computer. Repeat process for additional RAM sticks.

  7. Screw the back plate of the RAM back onto the device.
    • Screw the back plate of the RAM back onto the device.

Ligne d'arrivée

Daniel Johnson

Membre depuis le 07/04/2013

102 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 17-6, Regan Spring 2013 Membre de l'équipe Cal Poly, Team 17-6, Regan Spring 2013

CPSU-REGAN-S13S17G6

5 membres

11 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 6

Total : 1,073