Aller au contenu principal

Introduction

This guide provides step by step instructions of how to replace a faulty keyboard.

Pièces

Aucune pièce spécifiée.

  1. Flip the laptop over so the bottom is facing up.
    • Flip the laptop over so the bottom is facing up.

    • Slide each of the three tabs on the bottom half of the assembly into the unlocked position.

  2. Gently lift the battery out of the computer.
    • Gently lift the battery out of the computer.

  3. Remove the single 3mm Phillips #00 screw that secures the wireless card cover.
    • Remove the single 3mm Phillips #00 screw that secures the wireless card cover.

  4. Remove the WIFI module cover. It will pull right off.
    • Remove the WIFI module cover. It will pull right off.

  5. Fix Kits pour iPhone X

    Finie la garantie ? Pas de soucis, nous avons de quoi réparer.

    Acheter maintenant

    Fix Kits pour iPhone X

    Finie la garantie ? Pas de soucis, nous avons de quoi réparer.

    Acheter maintenant
  6. Unplug the white and black wires from the WiFi module. Unplug the white and black wires from the WiFi module.
    • Unplug the white and black wires from the WiFi module.

  7. Remove the twelve 8mm button head Phillips #00 B8 screws.
    • Remove the twelve 8mm button head Phillips #00 B8 screws.

    • Remove the two 14 mm button head Phillips #00 B14 screws.

    • Remove the two 10 mm Phillips #00 battery compartment screws.

    • Remove the two 8 mm Phillips #00 screws.

  8. Remove the seven 4mm flat Phillips #00 screws.
    • Remove the seven 4mm flat Phillips #00 screws.

    • Remove the seven 20mm button head Phillips #00 screws.

  9. Use the plastic opening tool to pry the two halves apart.
    • Use the plastic opening tool to pry the two halves apart.

  10. Using a screw driver for assistance, pop open the plastic cover and snap it off of the hinges. Repeat on the opposite side.
    • Using a screw driver for assistance, pop open the plastic cover and snap it off of the hinges. Repeat on the opposite side.

  11. Remove the two 3mm Phillips #00 screws.
    • Remove the two 3mm Phillips #00 screws.

  12. Slide keyboard out and away from the upper assembly.
    • Slide keyboard out and away from the upper assembly.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Aditya Varkhedi

Membre depuis le 01/10/2013

104 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 14-8, Forte Fall 2013 Membre de l'équipe Cal Poly, Team 14-8, Forte Fall 2013

CPSU-FORTE-F13S14G8

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 544