Introduction

This guide will walk you through the process to replace your RAM.

Pièces

Aucune pièce nécessaire.

  1. Press down with your fingers while also applying a sliding motion on the latch buttons near the battery on the underside of your laptop.
    • Press down with your fingers while also applying a sliding motion on the latch buttons near the battery on the underside of your laptop.

  2. Lift the battery upward with your fingers out of the battery compartment.
    • Lift the battery upward with your fingers out of the battery compartment.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Place the laptop with the bottom facing up.
    • Place the laptop with the bottom facing up.

    • Observe the single 6mm Phillips #1 screw keeping the laptop panels in place.

  5. Using your Phillips #1 screwdriver, unscrew the 6mm screw on the panel, exposing the hard drive and RAM. Using your Phillips #1 screwdriver, unscrew the 6mm screw on the panel, exposing the hard drive and RAM.
    • Using your Phillips #1 screwdriver, unscrew the 6mm screw on the panel, exposing the hard drive and RAM.

  6. Once the ram chip is exposed, push the two clips away from the ram chip to release it. (Clips move in direction of arrows.)
    • Once the ram chip is exposed, push the two clips away from the ram chip to release it. (Clips move in direction of arrows.)

  7. The ram chip will tilt up  after the clips are released.
    • The ram chip will tilt up after the clips are released.

    • Using your fingers, pull the ram chip out at a slight angle.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Walker Tortorigi

Membre depuis le 29/01/2018

468 Réputation

4 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 2

Total : 100