Toshiba Satellite C655D-S5200 LCD Replacement

Introduction

Typical Toshiba and no service manuals available. The LCD on this laptop was removed for other purposes. This is a straight forward task and only requires minimal tools.

Ce dont vous avez besoin

Étape 1 LCD

Toshiba Satellite C655D-S5200 LCD Replacement, LCD: étape 1, image 1 de 3

Toshiba Satellite C655D-S5200 LCD Replacement, LCD: étape 1, image 2 de 3

Toshiba Satellite C655D-S5200 LCD Replacement, LCD: étape 1, image 3 de 3

Here is the Toshiba Satellite C655D-S5200
Open the laptop with the LCD facing forward. There are four rubber caps, one in each corner
Removing the plugs reveal the Phillips screws

Modifier

Étape 2

Toshiba Satellite C655D-S5200 LCD Replacement: étape 2, image 3 de 3

Remove all four screws, tow on top left and right corner
One on the bottom left corner
and the bottom right corner.
Here are the four M3x5mm screws

Modifier

Étape 3

Toshiba Satellite C655D-S5200 LCD Replacement: étape 3, image 3 de 3

Use a plastic opening tool, or similar to pop the bezel of the LCD assembly
Continue to slide the tool all the way across the top
Once the bezel has been released from the tabs, it can be further released be applying some gently manual pulling

Modifier

Étape 4

Toshiba Satellite C655D-S5200 LCD Replacement: étape 4, image 3 de 3

Continue to pull gently on the sides
and finally on the bottom.
With all the tabs released the bezel can now be removed.

Modifier

Étape 5

Toshiba Satellite C655D-S5200 LCD Replacement: étape 5, image 3 de 3

Here is the LCD assembly without the bezel
Remove the Phillips screw that connects the LCD frame to the back cover. This is the left one
Remove the right one as well

Modifier

Étape 6

Toshiba Satellite C655D-S5200 LCD Replacement: étape 6, image 3 de 3

The LCD can now be moved forward and away from the rear cover
There are three screws on either side that hold the panel to the frame. Remove those
Here are the three M2x4 screws

Modifier

Étape 7

Toshiba Satellite C655D-S5200 LCD Replacement: étape 7, image 3 de 3

Remove the three Phillips screws on the right side as well.
with the screws removed the panel can now be moved out of the LCD frame. The LCD is still connected by the display cable.
The display cable is secured to the connector with some clear adhesive. Remove this frist