Pièces

Aucune pièce nécessaire.

With the battery away from you, slide the locking clips out.
  • With the battery away from you, slide the locking clips out.

    • The left clip stays, the right clip is spring loaded.

  • Slide the battery away from you.

Ajouter un commentaire

Use a spudger to carefully pry up the keyboard screw cover.
  • Use a spudger to carefully pry up the keyboard screw cover.

Ajouter un commentaire

  • Remove the two screws securing the keyboard to the chassis.

Ajouter un commentaire

  • Carefully tilt the keyboard towards you and release the ribbon cables.

  • Use a spudger if needed to release the latch. The latch slides out.

  • The keyboard is now free and can be set aside.

Ajouter un commentaire

  • Remove the five black screws

  • Remove the one silver screw

Ajouter un commentaire

  • Flip the laptop over so the bottom is facing up.

  • Using a spudger, remove the seven rubber inserts.

    • The feet only go in one location on the bottom of the laptop, so save yourself some time and track where they go.

Ajouter un commentaire

  • Remove the six silver screws.

  • Remove the one black screw.

Ajouter un commentaire

  • Stand the laptop up on end.

  • Remove the two rubber inserts from the back of the laptop. One insert is on each side of the laptop.

Ajouter un commentaire

  • Remove the two screews.

Ajouter un commentaire

  • Carefully work a spudger in the crack at the back of the laptop and separate the small rubberized section from the bottom of the laptop.

Ajouter un commentaire

  • Remove the four screws.

  • Disconnect the black wireless antenna lead.

Two outer are larger in diameter…

mitchgwin - Réponse

  • The bottom of the laptop is now ready to lift off.

  • Carefully work a spudger around the seam of the laptop separating the bottom from the rest of the laptop.

    • There is a data connection at the front of the laptop that needs to be disconnected.

    • Use a spuder to carefully disconnect the wire from the motherboard. Once this is free the bottom will come off.

Another data connection at rear near battery…

mitchgwin - Réponse

  • Locate the hard drive.

  • Remove the three screws.

  • Slide the hard drive out away from the motherboard connector.

    • Once the hard drive is disconnected it lifts out.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Tyler

Membre depuis le 19/06/2012

4 117 Réputation

16 tutoriels rédigés

Équipe

TechForce Membre de l'équipe TechForce

Business

2 membres

18 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 7

30 derniers jours : 36

Total : 2,489