Introduction

This guide will show you how to replace your front camera.

Pièces

Aucune pièce nécessaire.

Make sure the lock switch for the back cover is unlocked.
  • Make sure the lock switch for the back cover is unlocked.

    • The cover is unlocked when the switch is slid in the direction of the 'unlock' icon.

Ajouter un commentaire

Remove back cover by prying away from the Thrive.
  • Remove back cover by prying away from the Thrive.

    • The easiest place to pry from is one of the two speakers.

Ajouter un commentaire

  • To remove the battery, make sure the lock switch is in the unlocked position.

    • The battery is unlocked when the switch is slid to the unlocked position.

Ajouter un commentaire

  • Slide the battery switch release to the right.

    • While holding the switch in place, lift up the battery.

Ajouter un commentaire

  • Start by using a screwdriver to remove the 12 screws holding on the back cover. The screws are 5mm in length and require a PH0 screwdriver.

    • All of these screws are identical so don't worry about getting them mixed up.

Ajouter un commentaire

  • Start to gently pry the back of the device off, while leaving it loosely in place.

    • Be careful not to tear or damage the cables when removing the back.

Ajouter un commentaire

  • Once the back of the case is off, disconnect the wires by gently pulling on the plastic tabs as shown.

Ajouter un commentaire

  • Carefully open the device like a book and lay the two halves beside each other.

Can you add a picture of somebody opening the device?

Dan Brown - Réponse

  • Separate the two halves of your Thrive

  • Using a Phillips screwdriver, remove the six screws holding the LCD in place. These screws are 3mm in length and require a PH0 screwdriver.

Pictures suddenly get blue here. You could use substitutes, redo these, or fix them with a photo editor.

Dan Brown - Réponse

Well I separated the halves but I don't know how to reconnect it. I don't really know how i got it separated.

Sun Fai Lau - Réponse

  • With a spudger, disconnect the cable connecting the camera to the motherboard.

Ajouter un commentaire

  • Lift up the LCD from the screen and place it on the side

Ajouter un commentaire

  • Remove the one screw holding the camera in place. The screw is 3mm in length and requires a PH0 screwdriver.

  • Lift up the camera from the screen.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kason

Membre depuis le 22/09/2014

945 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team 10-1, Brown Fall 2014 Membre de l'équipe USF Tampa, Team 10-1, Brown Fall 2014

USFT-BROWN-F14S10G1

3 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 301