Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a 3/16" Allen Wrench to remove the silver cap.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a 7/32" Allen Wrench to remove the two bolts; 1 and 2. These clamp the stem to the steerer tube of the fork.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the handlebar by lifting vertically away from the frame.
-
Be careful to lift up only the handlebars and stem. If you lift up by the frame the headset and fork might come lose.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
To reassemble, slide the stem with and handlebar on to the steerer tube of the fork carefully.
-
Place silver cap on and tighten the bolt with a 3/16" Allen Wrench. This is done first so that the the headset is compressed between the frame and steerer tube of the fork.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
By hand you can now adjust the positioning of the stem and handlebar so that is in line with the front wheel of the bike.
-
Tighten the two bolts; [I] and [II] with a 7/32" Allen Wrench . These clamp the stem to the steerer tube of the fork.
-
Make sure that after tightening bolt [II] you go back and make sure you check the tightness of bolt [I] again. Since the bolts are used to clamp, bolt I will usually not be tight enough after tightening bolt [II].
-
Équipe
Cal Poly, Team 1-1, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 1-1, Propen Fall 2012
CPSU-PROPEN-F12S1G1
5 membres
9 tutoriels rédigés
