Danger
Potentiellement dangereux
Risque de blessure si cette procédure n'est pas suivie correctement. Faites preuve de prudence et suivez tous les avertissements.
Danger

Introduction

In order to have a safer biking experience, make sure your disk brake is properly replaced.

Pièces

Aucune pièce nécessaire.

  1. Begin loosening the tire by turning the quick release handle.
    • Begin loosening the tire by turning the quick release handle.

  2. Gripping the rear derailleur, pull the arm back, away from the front of the bike. Notice how the derailleur becomes almost vertical in the second picture when compared to the first.
    • Gripping the rear derailleur, pull the arm back, away from the front of the bike.

    • Notice how the derailleur becomes almost vertical in the second picture when compared to the first.

  3. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Vous avez déjà réparé quelque chose ? Vous êtes un génie.

    Partagez votre réparation avec le hashtag #ImAGenius

    Nous sommes tous des génies

    Partagez votre réparation avec le hashtag #ImAGenius

  4. There should be enough slack, in the chain, at this point to remove the tire from the bike. Note: You may need to wiggle the tire and chain around in order to create enough slack.
    • There should be enough slack, in the chain, at this point to remove the tire from the bike.

    • Note: You may need to wiggle the tire and chain around in order to create enough slack.

    • Remove the tire from the bike.

  5. Place the tire  flat on the ground making sure the disk is facing you.
    • Place the tire flat on the ground making sure the disk is facing you.

  6. Using the modular screw driver with a T25 bit, begin loosening and then removing the six 10mm-long screws. Make sure to keep track of all of the removed pieces. Make sure to keep track of all of the removed pieces.
    • Using the modular screw driver with a T25 bit, begin loosening and then removing the six 10mm-long screws.

    • Make sure to keep track of all of the removed pieces.

  7. After all of the screws have been removed, take the disk and pull it away from the tire. After all of the screws have been removed, take the disk and pull it away from the tire.
    • After all of the screws have been removed, take the disk and pull it away from the tire.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Daniel

Membre depuis le 27/01/2014

222 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 1-37, Maness Winter 2014 Membre de l'équipe Cal Poly, Team 1-37, Maness Winter 2014

CPSU-MANESS-W14S1G37

4 membres

6 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 331