Réparez vos affaires Communauté Boutique

ULCO ntegrus PSV ventilator Battery Replacement

Matériel médical
Ni iFixit ni ce tutoriel de réparation ne sont approuvés par ou affiliés au fabricant de ce dispositif médical.

Introduction

This guide will show you how to access and replace the battery of the ventilator.

Preparation to service:

  1. Make sure anaesthetic machine is OFF
  2. Disconnect the machine from power supply
  3. Gain access to ventilator housing from guide below





Ce dont vous avez besoin

    • Before disassembly, make sure the front wheel breaks are on.

    Traduire

    • Make sure ALL gas supplies are disconnected and the system has been purged, and make sure all electrical supplies have been disconnected.

    Traduire

  3. Traduire

  4. ULCO ntegrus PSV ventilator Battery Replacement: étape 4, image 1 de 1

    • With one hand on the ventilator removal handle and one holding the lower half of the ventilator, pull up firmly on the handle so that the mounting slides up the slots in the frame.

    Traduire

  5. ULCO ntegrus PSV ventilator Battery Replacement: étape 5, image 1 de 1

    • Pull the ventilator housing towards you so that the mounting tabs come out of the frame slots rest the ventilator housing on the plastic skirt at the rear of the workstation as shown in the photo.

    Traduire

  6. ULCO ntegrus PSV ventilator Battery Replacement, Battery: étape 6, image 1 de 1

    • Remove the main cover plate from the ventilator enclosure by removing all screws.

    Traduire

    • Disconnect the battery.

    Traduire

  8. ULCO ntegrus PSV ventilator Battery Replacement: étape 8, image 1 de 1

    • Remove the four pan head screws (SM0308P) holding down the battery plate (EV9109) and battery (EV9108) and remove the battery plate and battery.

    Traduire

  9. ULCO ntegrus PSV ventilator Battery Replacement: étape 9, image 1 de 1

    • Install the new battery in the same location and screw down the battery plate onto the battery plate spacers so that the battery is firmly held in place.

    Traduire

    • Reconnect the battery.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 2 autres contributeurs

Preston Myers

Membre depuis le 04/09/20

493 Réputation

4 tutoriels rédigés

Badges: 6

+ 3 badges supplémentaires

Équipe

Cal Poly, Team S7-G13, Paton Spring 2020 Membre de l'équipe Cal Poly, Team S7-G13, Paton Spring 2020

CPSU-PATON-S20S7G13

3 membres

8 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 6

30 derniers jours : 11

Total : 50