Introduction

We will teach you how to successfully take apart the phone system to do any repairs and be able to fully but it back together.

Pièces

Aucune pièce nécessaire.

Unplug the phone from the base by detaching the RJ-11 plug.
  • Unplug the phone from the base by detaching the RJ-11 plug.

  • Flip the base upside down, and use the Phillips #01 screwdriver to unscrew the seven screws (Head size: 5.11mm, length: 8.6mm) on the underside of the base.

Ajouter un commentaire

Using the spudger, separate the top shell of the base from the bottom shell from the base.
  • Using the spudger, separate the top shell of the base from the bottom shell from the base.

  • Use care when separating the base so the ribbon cable between the top shell circuit board and the bottom shell circuit board is not damaged!

Ajouter un commentaire

  • Unscrew the 3 screws (Head Size: 4mm Length: 8.6 mm) from the top shell circuit board.

Ajouter un commentaire

  • Unscrew the 2 screws (Head Size: 4mm Length: 8.66) on the small circuit board in the top shell.

Ajouter un commentaire

  • Disconnect the ribbon cable from the bottom shell circuit board.

Ajouter un commentaire

  • Release the speaker from the locking pin by pushing down on each ending side of the pin and pushing it away from the speaker.

Ajouter un commentaire

  • Remove rubber keyboard underlay from top shell.

Ajouter un commentaire

  • Push the plastic keyboard pieces out of the top shell.

Ajouter un commentaire

  • Unscrew bottom shell circuit board screws (Head size: 4mm Length: 8.6mm).

Ajouter un commentaire

  • The disassembly of the phone base is complete!

  • Now this guide will move on to taking apart one of the handsets.

Ajouter un commentaire

  • Slide the battery cover off of the handset, and unplug the battery.

Ajouter un commentaire

  • Remove the battery, and unscrew the two screws (Head Size: 4mm Length: 8.6 mm).

Ajouter un commentaire

  • Use spudger to separate the phone shell.

Ajouter un commentaire

  • Unscrew the two screws (Head Size: 4mm Length: 8.6mm) on the bottom shell keeping the speaker locking pin in place.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nicholas Weeks

Membre depuis le 27/01/2015

101 Réputation

1 tutoriel rédigé

Équipe

Pasco Hernando, Team 1-4, Prince Winter 2015 Membre de l'équipe Pasco Hernando, Team 1-4, Prince Winter 2015

PHSC-PRINCE-W15S1G4

6 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 2

Total : 325