Réparez vos affaires Communauté Boutique

Uniden Guardian G955 Speaker Replacement

Introduction

In this guide, you will learn how to open up the Uniden Guardian G955, unplug the speaker from the motherboard, and then replace the speaker in about 5 minutes.

Ce dont vous avez besoin

  1. Uniden Guardian G955 Speaker Replacement, Speaker: étape 1, image 1 de 1

    • Using a J1 Philips head screwdriver, unscrew all four 6.1 mm screws.

    Modifier

  2. Uniden Guardian G955 Speaker Replacement: étape 2, image 1 de 1

    • Using a metal spudger, open the monitor from the corner. Slowly slide the spudger around the case to prop open the case.

    Modifier

  4. Uniden Guardian G955 Speaker Replacement: étape 3, image 1 de 2 Uniden Guardian G955 Speaker Replacement: étape 3, image 2 de 2

    • Locate the circular speaker in one of the corners of the device. To release the speaker, pinch the metal fastener together and lift it off of the speaker.

    Modifier

  5. Uniden Guardian G955 Speaker Replacement: étape 4, image 1 de 2 Uniden Guardian G955 Speaker Replacement: étape 4, image 2 de 2

    • Follow the speaker towards the input on the motherboard. Pull it from the motherboard horizontally for it to loosen easier.

    • You may have to wiggle the head of the wire to efficiently remove it from the motherboard.

    Modifier

  6. Uniden Guardian G955 Speaker Replacement: étape 5, image 1 de 2 Uniden Guardian G955 Speaker Replacement: étape 5, image 2 de 2

    • Using an angled ESD tweezer, pull back on the black clamp with one hand while lifting the wires with the other hand.

    • You will have to apply a large amount of force on the black clamp to get it to move enough to lift the two wires out of it.

    Modifier

  7. Uniden Guardian G955 Speaker Replacement: étape 6, image 1 de 1

    • Carefully lift the speaker and all of the components in the speaker socket off of the monitor.

    • The speaker's film may be glued down to the socket where it's held. If this is the case, you must pull it all off and carefully clean it so that you may add the new speaker and ensure it fits with no leftover glue residue from the previous speaker.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 3 autres contributeurs

Fabian Demiro

Membre depuis le 10/06/16

177 Réputation

1 tutoriel rédigé

Badges: 9

+ 6 badges supplémentaires

Équipe

USF Tampa, Team 1-1, Nance Fall 2016 Membre de l'équipe USF Tampa, Team 1-1, Nance Fall 2016

USFT-NANCE-F16S1G1

3 membres

8 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 250