Place the phone facedown on a cleared work area
  • Place the phone facedown on a cleared work area

  • Remove the back case by applying moderate force to the indentation in the lower left corner of the case.

Ajouter un commentaire

Grip the top right corner of the battery.
  • Grip the top right corner of the battery.

  • Remove the battery by pulling it outwards.

Ajouter un commentaire

  • Remove the four screws on the back of the phone using a Philips 000 screwdriver

Ajouter un commentaire

  • Separate the frame evenly using a plastic opening tool.

  • Be careful, as the frame is thin and can break easily.

Ajouter un commentaire

  • Use a Phillips #000 screwdriver to remove the four screws that secure the motherboard.

Ajouter un commentaire

  • Disconnect the ribbon cable from the motherboard using rounded, spade-tipped tweezers.

Ajouter un commentaire

  • Peel the white circuit on left side of the frame by inserting fine-tipped tweezers between it and the frame.

  • The white circuit is flimsy and securely glued to the frame.

Ajouter un commentaire

  • Set aside the circuit board from the screen protector.

Ajouter un commentaire

  • Desolder the headphone jack using a soldering iron on each of the 6 points holding it down.

  • Be careful to not damage the circuit board.

Ajouter un commentaire

  • Solder on a new headphone jack.

Ajouter un commentaire

  • Make sure the new jack is aligned properly and securely soldered to the circuit board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

John Stavrianopoulos

Membre depuis le 08/02/2018

169 Réputation

2 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 34