Réparez vos affaires Communauté Boutique

VTech Kidizoom Smartwatch DX2 Camera Replacement

Introduction

If one of the cameras on your device is broken, cracked, or damaged in any way, the following guide will show you how to replace the camera.

Ce dont vous avez besoin

  1. VTech Kidizoom Smartwatch DX2 Camera Replacement, Master Switch: étape 1, image 1 de 2 VTech Kidizoom Smartwatch DX2 Camera Replacement, Master Switch: étape 1, image 2 de 2

    • Begin by flipping the watch over with its back facing upwards.

    Modifier

  2. VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 2, image 1 de 2 VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 2, image 2 de 2

    • Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.

    Modifier

  3. VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 3, image 1 de 2 VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 3, image 2 de 2

    • Gently lift the backplate up to remove it.

    Modifier

  5. VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 4, image 1 de 3 VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 4, image 2 de 3 VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 4, image 3 de 3

    • After removing the backplate, lift the master switch up from the circuit board.

    Modifier

  6. VTech Kidizoom Smartwatch DX2 Camera Replacement, Motherboard: étape 5, image 1 de 1

    • Using a Phillips #00 screwdriver, remove the 0.6 mm screw.

    Modifier

  7. VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 6, image 1 de 2 VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 6, image 2 de 2

    • Carefully remove the speaker from the case without disconnecting it from the motherboard.

    Modifier

  8. VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 7, image 1 de 2 VTech Kidizoom Smartwatch DX2 Camera Replacement: étape 7, image 2 de 2

    • Using the tweezers, carefully lift the bar holding the connection to the screen.

    • Remove the motherboard from the device.

    Modifier

  9. VTech Kidizoom Smartwatch DX2 Camera Replacement, Camera: étape 8, image 1 de 2 VTech Kidizoom Smartwatch DX2 Camera Replacement, Camera: étape 8, image 2 de 2

    • Turn the motherboard so the battery is on the bottom and locate the two clips holding the cameras in place.

    • Carefully lift the clips and slide the cameras out.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 4 autres contributeurs

Nathaniel Cady

Membre depuis le 10/26/18

181 Réputation

1 tutoriel rédigé

Badges: 8

+ 5 badges supplémentaires

Équipe

UMass Dartmouth, Team S3-G5, Peak Fall 2018 Membre de l'équipe UMass Dartmouth, Team S3-G5, Peak Fall 2018

UMASSD-PEAK-F18S3G5

4 membres

7 tutoriels rédigés

Un commentaire

to much and do not under stand it

Aaron Arora - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 5

Total : 759