Venturer CR20 Tuner Wheel Replacement

Introduction

In this guide, you will learn how to remove and install the tuner wheel of your alarm clock. The process consists of removing the front screen, followed by taking the hardware out of the housing and detaching the power cord. The following step consists of removing the top plastic from the motherboard, being sure to not fully remove the two.

Ce dont vous avez besoin

Étape 1 Front Screen

Venturer CR20 Tuner Wheel Replacement, Front Screen: étape 1, image 1 de 1

On the bottom of the clock locate and unscrew the single 2mm Phillips screw from bottom of the clock.

Modifier

Étape 2

Using a moderate amount of force, position the screwdriver in the crack between the front screen and the main body of the clock (as shown) and push the screen away from the main body of the clock.

Modifier

Étape 3 Power Cord

Venturer CR20 Tuner Wheel Replacement, Power Cord: étape 3, image 1 de 2

Venturer CR20 Tuner Wheel Replacement, Power Cord: étape 3, image 2 de 2

Get a firm grip on the outside of the clock and a firm grip on the hardware on the inside of the the clock like so and pull the hardware out from the outside of the clock.

Modifier

Étape 4

Venturer CR20 Tuner Wheel Replacement: étape 4, image 3 de 3

Using your fingers, pull the power cord connector, outlined in the picture with a red rectangle straight up to disconnect from the alarm clock.

Modifier

Étape 5 Tuner Wheel

Venturer CR20 Tuner Wheel Replacement, Tuner Wheel: étape 5, image 1 de 1

Just as before, pull the speaker plug directly up to remove the plug from the motherboard.

Modifier

Étape 6

Applying a bit of pressure at each of the contact points (illustrated by red circles), disconnect the display from the plastic housing.

Modifier

Étape 7

Venturer CR20 Tuner Wheel Replacement: étape 7, image 3 de 3

Do not pull the plastic frame and motherboard apart too hard or the motherboard and plastic frame will not go back together.
Flip the motherboard over and push in each of the black clips to disconnect the plastic frame from the motherboard.
Proceed to remove the plastic frame gently, being cautious to not fully break the two apart.