Aucune pièce nécessaire.

Remove nine 12mm Phillips screws from the upper back panel.
  • Remove nine 12mm Phillips screws from the upper back panel.

  • Remove three 12mm Phillips screws inset under the back panel.

  • As soon as the screws are removed, the panel will fall freely.

  • When replacing the twelve 12mm Phillips screws, do not tighten the fasteners until all twelve screws have been loosely fitted back onto the cooler. This will ensure the flimsy metal casing will not warp.

Ajouter un commentaire

Power Cord Fastener
  • Power Cord Fastener

  • Ground

  • Motherboard

  • Heat Sink Fan

  • Heat Sink

Ajouter un commentaire

  • Remove two 7mm Hex Nuts.

  • Clearance is minimal and these screws are very tight. You will likely need a socket wrench to avoid stripping.

  • If the white plastic components stick, pry them apart with a metal spudger. Don't pull on the power cord to get plastic pieces to separate.

Ajouter un commentaire

  • Remove one 12mm Phillips screw securing ground.

Ajouter un commentaire

  • Remove power cable from motherboard.

  • Pinch cable connector to release it from the motherboard, then pull.

Ajouter un commentaire

  • Your power cord is removed.

Ajouter un commentaire


To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Jeff Snyder

Membre depuis le 07/02/2013

2 590 Réputation

4 tutoriels rédigés


iFixit Membre de l'équipe iFixit


107 membres

6 505 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 522