Aller au contenu principal

Visual Land Prestige 7L Front Facing Camera Replacement

Ce dont vous avez besoin

  1. Visual Land Prestige 7L Front Facing Camera Replacement, Back Panel: étape 1, image 1 de 2 Visual Land Prestige 7L Front Facing Camera Replacement, Back Panel: étape 1, image 2 de 2
    • Remove the two 8mm Phillips Head screws located at the bottom of your device.

  2. Visual Land Prestige 7L Front Facing Camera Replacement: étape 2, image 1 de 3 Visual Land Prestige 7L Front Facing Camera Replacement: étape 2, image 2 de 3 Visual Land Prestige 7L Front Facing Camera Replacement: étape 2, image 3 de 3
    • Insert the spudger between the two pieces of the case around the media ports and pry them apart.

    • We found the best way to get the spudger inside the case was to insert in into the SD card slot. Be sure to only insert the spudger a shallow amount and be careful not to damage any of the inside of the device.

    • Finish unsnapping each plastic piece holding the device together along the bottom.

  3. Visual Land Prestige 7L Front Facing Camera Replacement: étape 3, image 1 de 3 Visual Land Prestige 7L Front Facing Camera Replacement: étape 3, image 2 de 3 Visual Land Prestige 7L Front Facing Camera Replacement: étape 3, image 3 de 3
    • Move the spudger down the rest of the case, separating each side, and finally the top.

    • Pull the back off and place it to the side.

    • Without a back panel for protection, be sure place your device on the table screen-side down to avoid damaging the internal circuitry.

  4. Visual Land Prestige 7L Front Facing Camera Replacement, Front Facing Camera: étape 4, image 1 de 2 Visual Land Prestige 7L Front Facing Camera Replacement, Front Facing Camera: étape 4, image 2 de 2
    • Remove the adhesive padding.

  5. Visual Land Prestige 7L Front Facing Camera Replacement: étape 5, image 1 de 2 Visual Land Prestige 7L Front Facing Camera Replacement: étape 5, image 2 de 2
    • Unclip the connector that attaches the camera to the motherboard.

    • For more information on unclipping connectors see this How To Guide

    • Do not pull on the camera until you're sure that it's unclipped, the gold connection will rip.

    • Gently pop the camera out of the connector and off the case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Greg Azzalina

Membre depuis le 01/28/15

263 Réputation

1 tutoriel rédigé

Équipe

Penn State, Team 2-25, Kaschak Winter 2015 Membre de l'équipe Penn State, Team 2-25, Kaschak Winter 2015

PSU-KASCHAK-W15S2G25

4 membres

4 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 3

7 derniers jours : 3

30 derniers jours : 10

Total : 283