Introduction
In this replacement guide, step by step instructions will show how to replace the circuit board located inside of the Vornado Duo.
Ce dont vous avez besoin
-
-
Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
Équipe
USF Tampa, Team S1-G1, Nance Fall 2017 Membre de l'équipe USF Tampa, Team S1-G1, Nance Fall 2017
USFT-NANCE-F17S1G1
3 membres
4 tutoriels rédigés
