Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Pièces

Aucune pièce spécifiée.

  1. Using a Phillips #1 screwdriver, remove the 4.8mm Phillips #1 screw on the battery cover by twisting the screwdriver counter-clockwise. Using a Phillips #1 screwdriver, remove the 4.8mm Phillips #1 screw on the battery cover by twisting the screwdriver counter-clockwise.
    • Using a Phillips #1 screwdriver, remove the 4.8mm Phillips #1 screw on the battery cover by twisting the screwdriver counter-clockwise.

  2. Then simply remove the two AAA batteries by pulling on one end of the battery and lifting it straight out. Then simply remove the two AAA batteries by pulling on one end of the battery and lifting it straight out. Then simply remove the two AAA batteries by pulling on one end of the battery and lifting it straight out.
    • Then simply remove the two AAA batteries by pulling on one end of the battery and lifting it straight out.

  3. Manta Precision Bit Set

    112 embouts pour toute réparation.

    Upgrade Your Toolbox

    Manta Precision Bit Set

    Upgrade Your Toolbox
  4. Take care when you want to close it. There is a notch. First you have to hook up that notch. Then firmly use a PH1 screwdriver to secure it.
    • Take care when you want to close it. There is a notch.

    • First you have to hook up that notch.

    • Then firmly use a PH1 screwdriver to secure it.

  5. Remove 4 13.8mm screws holding the device back using a Phillips #1 screw driver. Remove 4 13.8mm screws holding the device back using a Phillips #1 screw driver.
    • Remove 4 13.8mm screws holding the device back using a Phillips #1 screw driver.

  6. Lift directly up to remove the switch and lay the wire down to the side. Once the switch has been taken out you can remove the switch's casing. Once the switch has been taken out you can remove the switch's casing.
    • Lift directly up to remove the switch and lay the wire down to the side.

    • Once the switch has been taken out you can remove the switch's casing.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

tellocordova

Membre depuis le 04/09/2015

339 Réputation

2 tutoriels rédigés

Équipe

USF Tampa, Team 2-4, Sullivan Fall 2015 Membre de l'équipe USF Tampa, Team 2-4, Sullivan Fall 2015

USFT-SULLIVAN-F15S2G4

3 membres

6 tutoriels rédigés

Good work.

I have done it the same way,

the wire at the switch was bad soldered,

but it was easy to repair it and i soldered it new.

Nice.

Schwarzstein - Réponse

My baby’s phone keeps turning itself off. The switch is in the ON position but it keeps turning OFF and singing the off song. I have opened the phone and even held the switch to ON but it still keeps turning OFF even without the switch moving. Any suggestions?

shakinsher - Réponse

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 346