Introduction

The power switch connects the device motor to the power cord. If the power switch becomes broken or worn, the device may not function properly.

Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.
  • Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.

  • Make sure your device is not connected to power before you begin.

Ajouter un commentaire

Lift the bottom blade straight up from the device body to remove it.
  • Lift the bottom blade straight up from the device body to remove it.

Ajouter un commentaire

  • Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.

Ajouter un commentaire

  • Lift the base of blade assembly straight up off of the body.

Ajouter un commentaire

  • Remove the two 12.0 mm JIS #1 screws on the back of the device body.

Ajouter un commentaire

  • Remove the 13.0 mm Phillips #2 screw on the side of the device body.

    • This screw is located on the opposite side of the body from the switch.

Ajouter un commentaire

  • Remove the spring on the side of the body using tweezers.

Ajouter un commentaire

  • Pry the body case off of the device using a spudger.

Ajouter un commentaire

  • Remove one 7.5 mm JIS #1 screw connecting the power cord to the switch base.

Ajouter un commentaire

  • Remove one 7.5 mm JIS #1 screw connecting the wire to the switch base.

Ajouter un commentaire

  • Remove the switch from device by lifting straight up from the device body.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Holly Dunn

Membre depuis le 09/11/2017

101 Réputation

1 tutoriel rédigé

Équipe

IUPUI, Team S7-G3, Baechle Fall 2017 Membre de l'équipe IUPUI, Team S7-G3, Baechle Fall 2017

IUPUI-BAECHLE-F17S7G3

3 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 6

Total : 74