Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

If the blades to your Wahl Lithium Ion Trimmer are damaged or worn, this guide will show you how to replace them with functioning blades.

Blades can be damaged by being dropped, misused, or not being properly taken care of. In any of these circumstances, a replacement is typically required.

Because the blades are sharp, make sure to wear gloves or some sort of hand protection while handling the blades in order to avoid any sort of injury.

Before beginning this guide, make sure that the Wahl Lithium Ion Trimmer is powered off and disconnected from any source of electricity.

Pièces

Aucune pièce spécifiée.

  1. Examine the razor to identify any broken or jammed blades that require replacement. If any such blades are identified, the whole set must be changed.
    • Examine the razor to identify any broken or jammed blades that require replacement. If any such blades are identified, the whole set must be changed.

  2. Unscrew the two Phillips screws that hold the blades in place with a Phillips #0 screwdriver.
    • Unscrew the two Phillips screws that hold the blades in place with a Phillips #0 screwdriver.

  3. SAUTEZ LA MISE À NIVEAU

    Économisez en réparant avec un kit tout-en-un.

    Fix Kits pour iPhone

    SAUTEZ LA MISE À NIVEAU

    Économisez en réparant avec un kit tout-en-un.

    Fix Kits pour iPhone
  4. Apply pressure to the back side of the blades while pushing outward to remove the blade head completely from the Wahl Lithium Ion Trimmer. Apply pressure to the back side of the blades while pushing outward to remove the blade head completely from the Wahl Lithium Ion Trimmer.
    • Apply pressure to the back side of the blades while pushing outward to remove the blade head completely from the Wahl Lithium Ion Trimmer.

  5. Remove the metal clip using a Phillips #0 screwdriver. Remove the metal clip using a Phillips #0 screwdriver.
    • Remove the metal clip using a Phillips #0 screwdriver.

  6. Separate the Wahl Lithium Ion Trimmer head into its four components. Remove the damaged blade and replace it with a new one.
    • Separate the Wahl Lithium Ion Trimmer head into its four components. Remove the damaged blade and replace it with a new one.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

nathan

Membre depuis le 22/10/2013

1 268 Réputation

6 tutoriels rédigés

Équipe

University of Maryland, Team 1-3, Shastany Fall 2013 Membre de l'équipe University of Maryland, Team 1-3, Shastany Fall 2013

UMD-SHASTANY-F13S1G3

3 membres

6 tutoriels rédigés

Where can I get replacement arms?

Sam - Réponse

Where can one obtain a new spring???

tinkrmann - Réponse

The spring popped out of the head, but your pictures are too blurry to see how it goes back together.

Mark Wilson - Réponse

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 1

7 derniers jours : 31

30 derniers jours : 114

Total : 11,118