Introduction

Use this guide to replace the motor of your device.

Pièces

Aucune pièce nécessaire.

Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver.
  • Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver.

Ajouter un commentaire

Remove the wires connected to the motor by firmly grasping both sides of a wire and wiggling until it is released.
  • Remove the wires connected to the motor by firmly grasping both sides of a wire and wiggling until it is released.

Ajouter un commentaire

  • Unscrew the two 20.5 mm Phillip head screw located on the motor using a Phillip's #1 screwdriver.

Ajouter un commentaire

  • Gently remove the motor from the device.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sophia Swearengin

Membre depuis le 26/09/2017

542 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S14-G5, Boczar Fall 2017 Membre de l'équipe USF Tampa, Team S14-G5, Boczar Fall 2017

USFT-BOCZAR-F17S14G5

2 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 8

Total : 73