Réparez vos affaires Communauté Boutique

N-Strike Nite Finder EX-3 Wire Replacement Guide

Introduction

If the laser does not turn on and the batteries are in good condition, then this problem may be because of a faulty wire. In order to replace the faulty wire causing your N-Strike Nite Finder EX-3 problems, follow the steps in this guide.

Ce dont vous avez besoin

  1. N-Strike Nite Finder EX-3 Wire Replacement Guide, Wire: étape 1, image 1 de 1

    • Place the blaster upside down on the table, and remove the screw in the bottom of the handle.

    • Remove the battery door and take the batteries out.

    Modifier

  2. N-Strike Nite Finder EX-3 Wire Replacement Guide: étape 2, image 1 de 3 N-Strike Nite Finder EX-3 Wire Replacement Guide: étape 2, image 2 de 3 N-Strike Nite Finder EX-3 Wire Replacement Guide: étape 2, image 3 de 3

    • Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.

    • Lift the side of the blaster to expose its internal parts.

    Modifier

  4. N-Strike Nite Finder EX-3 Wire Replacement Guide: étape 3, image 1 de 1

    • Visually inspect all the wires in order to find the break, fray, or any other problem.

    • Locate the end connections of the affected wire.

    Modifier

  5. N-Strike Nite Finder EX-3 Wire Replacement Guide: étape 4, image 1 de 1

    • Use a hot soldering iron to melt the solder at one end of the wire until the wire can be pulled free from the connection.

    • Repeat on the other end of the connection to remove the wire from the blaster.

    • (End points marked on image are for the black wire)

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 5 autres contributeurs

Kyle Schober

Membre depuis le 02/24/14

640 Réputation

5 tutoriels rédigés

Badges: 14

+ 11 badges supplémentaires

Équipe

Michigan Tech, Team 5-8, Lauer Spring 2014 Membre de l'équipe Michigan Tech, Team 5-8, Lauer Spring 2014

MTU-LAUER-S14S5G8

3 membres

13 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 911