Introduction

Replace Memory Module

Pièces

Aucune pièce nécessaire.

CAUTION:  Before you begin the following procedure, follow the safety instructions in the  Product Information Guide .
  • CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide .

  • NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface. If you leave the area, ground yourself again when you return to the computer.

  • NOTE: Memory modules purchased from Dell are covered under your computer warranty.

  • NOTE: To get maximum performance/dual-channel memory bandwidth capability, both memory module connectors must contain memory modules and the modules must be of the same size and configuration.

  • NOTICE: To help prevent damage to the system board, you must remove the main battery before you begin working inside the computer

    • With the computer still turned over, loosen the captive screw on the memory module cover and slide the cover toward the back of the computer to remove it.

Ajouter un commentaire

NOTICE:  To prevent damage to the memory module connector, do not use tools to spread the memory-module securing clips.
  • NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory-module securing clips.

  • Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.

Ajouter un commentaire

  • Remove the module from the connector on the system board.

Ajouter un commentaire

  • Align the notch on the edge of the memory module connector with the tab in the connector on the system board, and slide the module firmly into the connector at a 45-degree angle.

Ajouter un commentaire

  • Rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.

Ajouter un commentaire

  • Replace the memory cover. Align the notches in the cover with the tabs on the base, slide the cover toward the front of the computer, and tighten the captive screw.

Ajouter un commentaire

Ligne d'arrivée

2 autre(s) ont terminé cette réparation.

Johnathan Hammond

Membre depuis le 28/02/2018

35 317 Réputation

408 tutoriels rédigés

Équipe

Informative Technologies Inc. Membre de l'équipe Informative Technologies Inc.

Community

15 membres

917 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 31