Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Appuyez sur le bouton pour retirer la batterie situé sur le haut du contrôleur.
-
Retirez le conteneur de la batterie du contrôleur.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a pair of tweezers to peel the barcode sticker from the battery compartment.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
Outil utilisé dans cette étape :Spudger$2.99-
Insert a Spudger between the front and rear cases along the left edge of the controller.
-
Rotate the spudger toward the front of the controller, prying the two cases apart.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Insert a spudger between the front and rear cases, near the headphone jack.
-
Rotate the spudger toward the front of the controller to pry the two cases apart.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to remove the vibration motor cable, moving it upward from its socket on the logic board.
-
Lift the vibration motor out of the front case.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the vibration motor from the other side of the controller using the same method previously described.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lifting from the headphone jack and power plug, remove the logic board from the front case.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the rubber pad from the back of the input buttons.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using a pair of tweezers, remove the buttons from the front case.
-
A Button
-
B Button
-
X Button
-
Y Button
-
Start Button
-
Select Button
-
Guide Button
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using a pair of tweezers, lift the home button's LED ring out of the front case of the controller.
-
Annulation : je n'ai pas terminé ce tutoriel.
60 autres ont terminé cette réparation.
3 commentaires
Hello I have had an Xbox for about 1-2years and everything has been working fine until the A button on one of my controllers stopped working I don't think it has gunk or anything because I can press it down and it comes back up just that when I press it in screen nothing happens but the other buttons work fine
Thank you for the teardown! My cat has just vomitted on my joystick…. I could have cleaned it now! I appreciate it , thanks…
Has anyone ever replaced the spring contacts in the logic board???