Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Appuyez sur le bouton pour retirer la batterie situé sur le haut du contrôleur.
-
Retirez le conteneur de la batterie du contrôleur.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a pair of tweezers to peel the barcode sticker from the battery compartment.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Insert a Spudger between the front and rear cases along the left edge of the controller.
-
Rotate the spudger toward the front of the controller, prying the two cases apart.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Insert a spudger between the front and rear cases, near the headphone jack.
-
Rotate the spudger toward the front of the controller to pry the two cases apart.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to remove the vibration motor cable, moving it upward from its socket on the logic board.
-
Lift the vibration motor out of the front case.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the vibration motor from the other side of the controller using the same method previously described.
-
Annulation : je n'ai pas terminé ce tutoriel.
19 autres ont terminé cette réparation.
3 commentaires
Hello, I am very concerned about which side of the controller the motor with heavier counterweight should be. Shouldn’t it be on the left side of the controller, since the right side should be used for higher frequency vibrations?
Hi Yado,
Thanks for pointing this out! You are right—the left side have the heavier counterweight. I’ve corrected the relevant step.
Hi there, I believe that the screenshots provided have the vibration motors on the wrong sides. Watching several videos of the disassembly on youtube as well as taking apart my own controller that previously was never opened, the larger heavier motor should be on the right side and the smaller lighter motor should be on the left side.
