Introduction

Similar to the buttons, triggers can break during hardcore gaming or could lose functionality due to sticky and gooey substances (eg. food). In this guide, you will learn how to replace the left and right triggers of the controller. This guide involves opening the controller.

Turn the controller on its backside and push the "eject" button to discharge the battery compartment door on the bottom of the controller.
  • Turn the controller on its backside and push the "eject" button to discharge the battery compartment door on the bottom of the controller.

  • Pull the two AA batteries out.

Ajouter un commentaire

Lift the battery compartment out of the controller and set it outside of the controller.
  • Lift the battery compartment out of the controller and set it outside of the controller.

    • Do not yank, stress, or pull on the wires for removal.

  • Use the precision tweezers to pull out the red and black wire attached to the white plug at the bottom side of the circuit board.

Ajouter un commentaire

  • Remove the holographic Microsoft sticker with the percision tweezers to reveal a small screw.

  • Use a T6 Torx screwdriver to remove the 1.5mm screw.

Ajouter un commentaire

  • Insert a spudger and pry at these three locations to detach the middle cover.

  • Pull off the middle piece cover to reveal three screws.

  • Use a T8 Torx screwdriver to remove the three 2.3mm screws.

  • Remove the cover.

Ajouter un commentaire

  • Remove the two 90mm screws with a T8 Torx screwdriver.

  • Lift up the silver middle piece to remove.

Ajouter un commentaire

  • Use a spudger to remove the silver prong.

  • With the spudger, pinch the metal spring and slowly pull up to remove.

    • Use the spudger to remove eject button.

  • Remove the screw holding in the eject button with a T8 Torx screwdriver.

Ajouter un commentaire

  • This step is very difficult and may require a third hand.

  • Pull the two halves apart at the bottom to detach the two latches that are holding the front and back panels together.

  • Start with one side of the controller (left or right).

  • Slide the spudger towards the end of the handles and pry the two halves apart. Do the same for the opposite side.

  • The white circular caps at the top of the controller will pop off by applying light force.

  • Pull the front and back panels apart to separate them and expose the inside of the controller.

Ajouter un commentaire

  • Use precision tweezers to remove the red and black wires that are attached to the circuit board.

  • The rumble motors will easily lift out of the controller once the wires are detached.

Ajouter un commentaire

  • Use a T6 Torx screwdriver to remove the four 2.3mm screws.

  • Lift up the black locking tab on the ZIF connector to release the ribbon cable.

Ajouter un commentaire

  • Lift up the trigger to remove it from the controller.

  • The trigger is made up of three pieces: the trigger, a circuit board, and a ribbon cable.

  • Repeat for the other trigger.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

ines said

Membre depuis le 15/02/2018

85 Réputation

1 tutoriel rédigé

Équipe

USF Tampa, Team S16-G5, Boczar Spring 2018 Membre de l'équipe USF Tampa, Team S16-G5, Boczar Spring 2018

USFT-BOCZAR-S18S16G5

5 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 5

Total : 79