Introduction
Les capuchons du joystick de votre manette Xbox peuvent ne plus répondre ou devenir collants. Si cela se produit, il peut être nécessaire de les retirer pour les remplacer ou les nettoyer. Ce tutoriel vous apprendra comment accéder et remplacer les joysticks de votre manette sans fil Xbox One modèle 1708.
Ce dont vous avez besoin
-
-
Faites glisser le cache du compartiment de la batterie vers le haut de la manette pour le retirer.
-
Soulevez la batterie rechargeable ou les piles pour les sortir du compartiment.
-
-
-
-
Fixez les moteurs de vibration à l'aide de ruban adhésif.
-
Cela évitera que les moteurs ne tombent.
-
Pour remonter votre appareil, suivez les étapes dans l'ordre inverse.
Pour remonter votre appareil, suivez les étapes dans l'ordre inverse.
Annulation : je n'ai pas terminé ce tutoriel.
133 autres ont terminé cette réparation.
Merci à ces traducteurs :
100%
Ces traducteurs nous aident réparer le monde ! Vous voulez contribuer ?
Commencez à traduire ›
Équipe
Cal Poly, Team S18-G3, Forte Fall 2017 Membre de l'équipe Cal Poly, Team S18-G3, Forte Fall 2017
CPSU-FORTE-F17S18G3
4 membres
32 tutoriels rédigés
6 commentaires
How about the square thing with the stick and hinges that the joystick is attached to? I think it’s called the Module. I have a joystick drift / drifting problem and that may help me out. Thanks.
Agreed. That’s actually the part I need to replace too. The module.
followed this guide to take the controller apart because I had a joystick that was sticking, my solution was to put some 3in1 oil on the module that was sticking and it seems to be working a lot better now.
@corytc and @tomchak I did replace the module, in general, you buy (Amazon or eBay) you will receive a module of 6 modules you need a multimeter and test each module interface, measure both resistances and subtract them, the one nearest zero is the module you will use since is the one with least drift from the factory.
Just disassemble it, turn upside down uses a solder remover and unsolder the old one, place the new one solder back, boom you are done.
Like you will need an iron solder with medium and thin tips, I used lead-free solder, so is a patience test, be careful with the wires from the rumbles, try not to unsolder them since is a thin wire and is difficult, like I have big hands so took me a while to solder back.
Just want to say the hardest part is carefully prying off the plastic covers on the handles. It’s also not necessary to remove the back cover for simply replacing the joysticks. Other than that, it’s very easy. I would guess this is rated at moderate difficulty simply due to the plastic covers.
