Introduction

Use this guide to install a replacement keyboard display.

  1. Turn the keyboard over so that the keys are facing the ground.
    • Turn the keyboard over so that the keys are facing the ground.

    Ajouter un commentaire

  2. Pop the tabs on the battery casing and remove it from the back plate.
    • Pop the tabs on the battery casing and remove it from the back plate.

    Ajouter un commentaire

    • Locate the six batteries and remove them from the battery cavity.

    what type of batteries? and how much ?

    thanks godbless

    colladonelson - Réponse

    • Remove the six 10mm screws at the top of the backplate.

    Ajouter un commentaire

    • Remove the seven 12mm screws in the middle of the back plate.

    Ajouter un commentaire

  3. Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    • Remove the eight 10mm screws from the side and the bottom of the back plate.

    Ajouter un commentaire

    • As the face plate is no longer connected to the body of the keyboard, be careful to not drop the body when performing this step.

    • Flip over the keyboard

    Ajouter un commentaire

    • Lifting from the front and the back of the face plate equally, pull the face plate up and then back, away from the keyboard.

      • Be careful when removing the face plate. There are wires attached.

    Ajouter un commentaire

    • Locate the main circuit board - it should be toward the middle of the detached face plate.

    Ajouter un commentaire

    • Use a plastic opening tool or spudger to carefully pry up the beige ribbon connectors and remove the wires from them.

      • Be sure to use a tool that is ESD safe!

      • Use a slightly upward force as parallel to the ground as possible.

      • Be sure to make a mental note or jot down the locations of the specific ribbon cables. Some are in close proximity to each other and it can be easy to forget which ribbon goes where.

    • Be sure to unplug the smaller ribbon that connects to a different circuit board.

    • Take care not to use too much force. The connectors are fragile, the ribbon wires are easily bent, and too much force may damage the circuit board if you happen to miss.

    Ajouter un commentaire

    • Move the ribbons out of the way and remove the eight 10mms crews in the middle that hold the circuit board down.

    • Remove the two 12mm screws in the corner of the circuit board.

    Ajouter un commentaire

    • Remove this wire carefully by hand.

    Ajouter un commentaire

    • Completely remove the circuit board from the face plate.

    Ajouter un commentaire

    • Slide out the screen from its case on the circuit board.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Lonnie Bissmeyer

Membre depuis le 16/09/2012

300 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 2-62, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 2-62, Propen Fall 2012

CPSU-PROPEN-F12S2G62

2 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 15

30 derniers jours : 37

Total : 2,743