Aller au contenu principal

Introduction

This guide provides the steps necessary to replace the front-facing camera on the ZTE ZFive G LTE.

  1. Using the opening tool, pry open the rear cover from the crease at the bottom left corner. Using the opening tool, pry open the rear cover from the crease at the bottom left corner. Using the opening tool, pry open the rear cover from the crease at the bottom left corner.
    • Using the opening tool, pry open the rear cover from the crease at the bottom left corner.

  2. Remove the battery with an opening tool or fingernail. Remove the battery with an opening tool or fingernail. Remove the battery with an opening tool or fingernail.
    • Remove the battery with an opening tool or fingernail.

  3. Batteries pour ordinateurs portables

    Batteries pour toutes les grandes marques d'ordinateurs portables. Qualité assurée par notre garantie.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Batteries pour toutes les grandes marques d'ordinateurs portables. Qualité assurée par notre garantie.

    Acheter maintenant
  4. Unscrew all 16 screws from the mid-frame J000 screwdriver.
    • Unscrew all 16 screws from the mid-frame J000 screwdriver.

    • Set the screws aside.

  5. Gently pull up the device body from the inside. Make sure to pull on all four sides as shown here.
    • Gently pull up the device body from the inside.

    • Make sure to pull on all four sides as shown here.

  6. Once the body is removed, you will see the front facing camera at the top right corner of the device. Using an opening tool, lift up the protective clip on top of the camera's ribbon wire.
    • Once the body is removed, you will see the front facing camera at the top right corner of the device.

    • Using an opening tool, lift up the protective clip on top of the camera's ribbon wire.

  7. Using angled tweezers, gently pull the ribbon wire up from the body. With the ribbon wire out, you should be able to remove the camera.
    • Using angled tweezers, gently pull the ribbon wire up from the body.

    • With the ribbon wire out, you should be able to remove the camera.

    • If there is adhesive on the camera backing, it may require more force to pull the camera out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Julian Mendoza

Membre depuis le 21/09/2018

704 Réputation

5 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 4

Total : 196