1. Turn the device over with its display down.
    • Turn the device over with its display down.

  2. Remove the battery cover, pressing down on the tabs and sliding.
    • Remove the battery cover, pressing down on the tabs and sliding.

  3. Unscrew the two (2)  #00, 10 mm screws located below the mic on the back cover.
    • Unscrew the two (2) #00, 10 mm screws located below the mic on the back cover.

  4. Carefully pry up the top end of the back cover using one finger.
    • Carefully pry up the top end of the back cover using one finger.

  5. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Avez-vous jamais réparé quelque chose ? C’est génial.

    Share your repair story with #ImAGenius

    Nous sommes tous des génies

    Share your repair story with #ImAGenius

  6. Remove the back plate by using a plastic removal tool to pry the back cover up around the edges.
    • Remove the back plate by using a plastic removal tool to pry the back cover up around the edges.

  7. Unscrew the circuit board screw.
    • Unscrew the circuit board screw.

    • This screw is located down near the bottom of the device on the blue circuit board. It is just to the right of the USB port.

  8. Use a plastic removal tool to disconnect the blue  circuit board from the green circuit board underneath.
    • Use a plastic removal tool to disconnect the blue circuit board from the green circuit board underneath.

  9. Turn the circuit board on its side to reveal the USB soldering points.
    • Turn the circuit board on its side to reveal the USB soldering points.

  10. De-solder the USB port from its four soldering points.
    • De-solder the USB port from its four soldering points.

    • Be careful not to damage the wire connected to the USB port during de-soldering.

  11. Place the new USB port in the same spot on the board, and re-solder at each of the four points.
    • Place the new USB port in the same spot on the board, and re-solder at each of the four points.

    • Ensure you re-solder the wire into the same connection you removed it from during desoldering

  12. Rotate the circuit board back to its initial position, with the port on the underside of the board.
    • Rotate the circuit board back to its initial position, with the port on the underside of the board.

  13. Replace the circuit board screw.
    • Replace the circuit board screw.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Alex

Membre depuis le 28/10/2013

758 Réputation

5 tutoriels rédigés

the third screw is on the outside of the case, the same place

xhbang - Réponse

This is awesome. Do you know if I can switch the port for USB-C?

Regan Ryan - Réponse

Voir les statistiques:

Dernières 24 heures : 5

7 derniers jours : 20

30 derniers jours : 57

Total : 2,789