Réparez vos affaires Communauté Boutique

Zoomer Dino Boomer Back Button Replacement

Introduction

This guide involves taking apart the Zoomer Dino Boomer in order to disconnect the sensor button from the main circuit board for replacement.

Ce dont vous avez besoin

  1. Zoomer Dino Boomer Back Button Replacement, Back Cover: étape 1, image 1 de 1

    • Power off Zoomer Dino Boomer before disassembly.

    • Remove the eight 9.3mm Phillips #1 screws.

    Traduire

  2. Zoomer Dino Boomer Back Button Replacement: étape 2, image 1 de 2 Zoomer Dino Boomer Back Button Replacement: étape 2, image 2 de 2

    • Turn dinosaur over and hold upright.

    • Use the spudger to pry apart the back cover from the remainder of the Zoomer Dino Boomer.

    • Be gentle while removing the back cover. The back cover of the Zoomer Dino Boomer is still connected to the electronic system by a wire.

    Traduire

  4. Zoomer Dino Boomer Back Button Replacement: étape 3, image 1 de 3 Zoomer Dino Boomer Back Button Replacement: étape 3, image 2 de 3 Zoomer Dino Boomer Back Button Replacement: étape 3, image 3 de 3

    • Disconnect the wire that connects the back cover of the dino to the main circuit board by carefully pulling on the orange wire connector with tweezers.

    • Remove back cover.

    • If you are having difficulty removing the connector from its socket, push in the small tabs on the side of the connector with the tweezers. This step may take some work.

    • Do not damage the wires or circuit board.

    Traduire

  5. Zoomer Dino Boomer Back Button Replacement, Back Button: étape 4, image 1 de 1

    • Where the button is largest, squeeze the two white tabs together.

    Traduire

  6. Zoomer Dino Boomer Back Button Replacement: étape 5, image 1 de 1

    • Push in the white circular piece between these tabs as far as it will go.

    Traduire

  7. Zoomer Dino Boomer Back Button Replacement: étape 6, image 1 de 2 Zoomer Dino Boomer Back Button Replacement: étape 6, image 2 de 2

    • Where the button is smallest, squeeze the two white tabs together and press the circular tab in-between them until the button comes loose.

    • Remove the back button.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 2 autres contributeurs

Lauren Mannix

Membre depuis le 08/29/15

398 Réputation

3 tutoriels rédigés

Badges: 11

+ 8 badges supplémentaires

Équipe

USF Tampa, Team 16-1, Wollert Fall 2015 Membre de l'équipe USF Tampa, Team 16-1, Wollert Fall 2015

USFT-WOLLERT-F15S16G1

3 membres

10 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 8

Total : 2,004