Introduction

This is a guide to replace the legs of the Zoomer Meowzies. Removing the legs is a prerequisite to the replacment guides for the Infrared Sensors, LED Screen “Eyes,” and the Speaker.

Pièces

Aucune pièce nécessaire.

Using the Triangle driver remove the four 7.5 mm screws.
  • Using the Triangle driver remove the four 7.5 mm screws.

  • The two front screws are deeper than the two on the back legs which may cause difficulties. These can be reached by putting the bit in first then carefully putting the driver on slightly (not all the way)

Ajouter un commentaire

Turn the device so that the the device is on its side.
  • Turn the device so that the the device is on its side.

  • Hold the back and belly on the device and gently pull apart.

  • Pulling with too much force might damage a few cables inside, so caution is needed.

Ajouter un commentaire

  • With insides exposed, grab leg and gently pull up and away from the body to detach them. Repeat for all legs needed.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Muataz Alahmadi

Membre depuis le 14/02/2018

193 Réputation

2 tutoriels rédigés

Équipe

USF Tampa, Team S6-G2, Eyestone Spring 2018 Membre de l'équipe USF Tampa, Team S6-G2, Eyestone Spring 2018

USFT-EYESTONE-S18S6G2

3 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 32