Introduction
Are you going to throw away your expensive massage pillow just because the heater is broken? Here is a simple guide to replace your broken heater so that your massage pillow can work again.
Ce dont vous avez besoin
-
-
-
Disconnect the power plug located on the back of the massage pillow.
Demander à FixBot
-
-
-
Unzip the cover. You can locate the zipper at the back of the massage pillow.
-
Take out the pillow so that you can manage the heater completely.
-
-
-
Use a Phillips JIS #1 screwdriver to remove the screw at the center of the heater.
-
-
-
-
Remove the entire heater from the pillow.
-
You can see a green circuit board after removing the heater.
-
-
-
Using the Phillips JIS #1 screwdriver, remove the three screws circled in the picture.
-
-
-
Now you can take out the circuit board. There will be two wires attached to the circuit board.
-
If you prefer, you can clean the circuit board gently with dry tissues to remove the sticky lubricant.
-
-
-
Using your soldering station, remove the wires from the circuit board.
-
Now, you can separate the circuit board completely to replace with a new heater.
-
-
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.
Équipe
Cal Poly, Team 14-2, Green Fall 2015 Membre de l'équipe Cal Poly, Team 14-2, Green Fall 2015
CPSU-GREEN-F15S14G2
4 membres
48 tutoriels rédigés
2 commentaires de tutoriel
Hi YuChen, nice work! Do you know from where I can find the switch for this heater? If you can tell me the part number, I can try looking it up on eBay. Thanks!
