Introduction

A simple fix for any screen issues on a bObsweep Pethair.

Video instructions:

Vidéo d'introduction

Flip Bob over and remove the 7 screws around which hold the cover together.
  • Flip Bob over and remove the 7 screws around which hold the cover together.

    • Remove the main brush. Unscrew the holder, and lift the brush out. Reminder: Keep this screw separate from the others so you can use it later to reinstall.

    • Depending on your model, there may be only 6 screws installed on bObsweep.

Ajouter un commentaire

There are two screw holes inside the brush compartment: one in the centre, one on the left end. Remove both and keep aside for reassembly.
  • There are two screw holes inside the brush compartment: one in the centre, one on the left end. Remove both and keep aside for reassembly.

  • There are five more screws around bObsweep's edges. Two are installed at the top and bottom, and one on the right end of the main brush.

Ajouter un commentaire

  • Flip bOb back over so you can see the screen. Lift the cover up to reveal bObsweep’s main board.

  • Detach the power inlet from the cover. Grip and slide it out.

Ajouter un commentaire

  • Remove three circuit plugs from the motherboard. Pinch the small white tab on the side of each circuit plug and pull straight up to release each from the motherboard.

    • 1. On the bottom left corner: a small connector with red, black and white wires.

    • 2. One thick white wire that attaches on the right side of the previous connector.

    • 3. On the top edge of bOb’s motherboard: a wide multicoloured connector.

  • Place the cover aside and begin your repair.

Ajouter un commentaire

  • Remove the four screws holding the screen in place

  • Lift the screen up and it will detach from the cover.

Ajouter un commentaire

  • The screen and cover buttons will lift out together, leaving an open space for your replacement parts to fit into.

  • If you remove the infrared sensor, replace it in its space on the new cover so the black side will be on bOb’s outside.

  • Then, install all four screws for the LCD display. To finish off the repair, simply follow: Closing bObsweep's cover after repair

Ajouter un commentaire

Conclusion

To reassemble your device, follow the guide for closing bObsweep after repair.

Tatiana

Membre depuis le 28/06/2014

707 Réputation

17 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 84