Aller au contenu principal

Modifications apportées à l'étape #2

Modifié par Lonnie Bissmeyer

Modification approuvée par Lonnie Bissmeyer

Supprimé(e)
Ajouté(e)
Inchangé

Lignes de l'étape

[* black] Using a flat head screwdriver, carefully pry up the beige ribbon connectors and remove the wires from them.
[* icon_note] Be sure to make a mental note or jot down the locations of the specific ribbon cables. Some are in close proximity to each other and it can be easy to forget which ribbon goes where.
[* black] Use a slightly upward force with the screwdriver as parallel to the ground as possible.
[* black] Don't forget about the smaller ribbon that connects to a different part of the circuitry.
[* icon_caution] Take care not to use too much force. The connectors are fragile and the ribbon wires are easily bent, and too much force may damage the circuit board if you happen to miss.

Image 2

Aucune image précédente

Ajouté(e)